Will fit 33 - 34 Fords Cars and Trucks
When building a street rod, throwing a modern day V8 motor in older day cars and driving the
higher speeds that we drive today, boxing in the original flimsy frames is a must.
Our "Easy Weld" boxing plates are cut undersized so that they would basically slip inside the
original frame rails, to allow for a V gap for great weld penetration, without the worry of grinding
away too much weld and sacrificing strength when grinding the welds flush. There are steps or
outward notches incorporated into our boxing plates to prevent them from slipping inside the
frame and making fitting and adjusting difficult.
These are cut from 10 gauge (slightly thicker than 1/8") steel to give added strength when
welding motor mounts, crossmembers and etc to the inside of the chassis.
This is a 10 piece set. Our boxing plates are Completely Full Length and fit very accurately,
unlike many others. As shown in the pictures, they were designed so that the pieces start/end
at crossmember intersections. This allows the builder total choice on how to use them. Use the
entire full length, or leave your crossmembers in and trim the boxing plates accordingly. The
outward notches can also be cut or ground off so that you can slip the plates inside the rails for
the stepped style boxing. This set is very versatile, which allows the builder to pick what he
wants to do.
To state the obvious..some assembly, fitting and welding is required.
When building a street rod, throwing a modern day V8 motor in older day cars and driving the
higher speeds that we drive today, boxing in the original flimsy frames is a must.
Our "Easy Weld" boxing plates are cut undersized so that they would basically slip inside the
original frame rails, to allow for a V gap for great weld penetration, without the worry of grinding
away too much weld and sacrificing strength when grinding the welds flush. There are steps or
outward notches incorporated into our boxing plates to prevent them from slipping inside the
frame and making fitting and adjusting difficult.
These are cut from 10 gauge (slightly thicker than 1/8") steel to give added strength when
welding motor mounts, crossmembers and etc to the inside of the chassis.
This is a 10 piece set. Our boxing plates are Completely Full Length and fit very accurately,
unlike many others. As shown in the pictures, they were designed so that the pieces start/end
at crossmember intersections. This allows the builder total choice on how to use them. Use the
entire full length, or leave your crossmembers in and trim the boxing plates accordingly. The
outward notches can also be cut or ground off so that you can slip the plates inside the rails for
the stepped style boxing. This set is very versatile, which allows the builder to pick what he
wants to do.
To state the obvious..some assembly, fitting and welding is required.
 |  |  |  |  |  |  |  |
| 33 - 34 Ford SOLID Boxing Plates (10 Gauge) $200 |
| 1933 - 1934 Ford "Easy Weld" Boxing Plates |
| 33 - 34 Ford DIMPLED Boxing Plates (10 Gauge) $375 |
Purchase Partial Sets From multiple requests to purchase individual sections, we now have them available online. Please allow 1 week (2 weeks max) for us to get partial set orders completed, as we only keep full sets in stock boxed and ready to go, and these orders are dealt with one at a time. See the picture above showing the crossmember junctions to determine which pieces you want. |
| Like our Products or Services? Post comments/pictures on our Facebook page! Then "Like" and Share with your Friends! |
